1 ( unnamed net_device ) ( uninitialized ) : Failed to detect MCP25xxFD ( osc = 0x00000000 ). 0 ( - RX_INT + MAB_NO_WARN + CRC_REG + CRC_RX + CRC_TX + ECC - HD m : 20.00 MHz r : 18.50 MHz e : 0.00 MHz ) successfully initialized. Pi raspberrypi : ~ $ dmesg | grep spi mcp25xxfd spi0. Use the jumpers to connect the CAN terminal of both shield. Plug the CAN BUS Shield V2 into the Seeeduino(or Arduino) Board Follow the Mounting Guide to Plug the 2-Channel CAN-BUS(FD) Shield into Raspberry. Getting Started В¶ Materials required В¶ Raspberry piДЄlso we need to two male to male jumper and power cables to power those boards. Transfer 20AWG shielded 20AWG shielded cable

So please be sure to assemble the nylon column as shown. You can see that we used nylon columns during assembly to avoid short-circuiting between the metal terminals under the CAN BUS port and the HDMI interface on the Raspberry Pi.

One-button configuration of 120О© terminating resistor.

Compatible with Raspberry Pi 2, Raspberry Pi 3, Raspberry Pi 3, Raspberry Pi 4 and Raspberry Pi Zero.

Stable power supply, selectable Raspberry Pi power supply or DC power supply.

High-speed transfer rate: 20AWG shielded cable / 20AWG shielded cable.

Product NameДў-Channel CAN-BUS(FD) Shield for RPi (MCP2517FD)Дў-Channel CAN-BUS(FD) Shield for Raspberry Pi (MCP2518FD)ДЄs you can see, there are two versions of chips used in the 2-Channel CAN-BUS(FD) Shield for RPi (MCP2517FD) and both channels work on RPi but only single channel (CAN0) works on the Jetson Nano Platform! Features В¶ The CAN BUS shield now also supports the Nvidia Jetson Nano platform, and different versions of the CAN BUS Shield do affect the functionality, please check the table below carefully if you're using with Jetson Nano Platform. All 3 versions work perfectly on Raspberry Pi platform, and may skip this section if you're using RPi platform. There are 3 versions of the CAN BUS shield for Raspberry Pi. CAN FD support much faster transmission speed(up to 8Mbps)ДЄlso it have two On-board 120О© terminating resistors which are controlled by the switches.

This is a CAN BUS shield for Raspberry Pi(hereinafter referred to as 2 channel pi hat), 2 channel CAN BUS I/O, support CAN FD. Edit 2 Channel CAN BUS FD Shield for Raspberry Pi

Ct-Shield V2.0